cuisinart coffee maker dcc-1100bk manual

The Cuisinart DCC-1100BK is a 12-cup programmable coffeemaker with a sleek stainless steel design. It features a 24-hour programmability, auto shut-off, a charcoal water filter, a brew pause function, and an adjustable warming plate. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel housing, 12-cup glass carafe, Charcoal water filter, LCD clock display, Control panel with buttons.

Installation

Unpack and inspect contents. Place on clean, dry, stable surface away from edges.

1. Remove all packaging materials from inside and outside the unit.
2. Wash carafe, lid, and filter basket with warm, soapy water. Rinse and dry.
3. Insert charcoal water filter into filter holder (soak filter first for 15 minutes).
4. Plug power cord into a standard 120V AC outlet.

WARNING! Do not place near heat sources or in direct sunlight. Ensure cord is not dangling.

First-Time Setup

Power on coffeemaker; set clock before programming.

1. Set the clock: Press and hold HOUR and MINUTE buttons to set current time.
2. Prime the filter: Run a cycle with water only (no coffee) to activate charcoal filter.
3. Program brew time: Press PROGRAM, then use HOUR/MINUTE to set desired start time.
4. Adjust warming plate: Use switch on side for Low or High temperature setting.

CAUTION! Handle carafe with care; it is glass and can break if dropped.

Specifications

• Capacity: 12 cups (5 oz per cup).
• Housing: Brushed stainless steel.
• Carafe: Glass with ergonomic handle and dripless spout.
• Filter: Permanent gold-tone filter; includes charcoal water filter.
• Programmability: 24-hour advance brew start.
• Auto Shut-Off: 0 to 4 hours adjustable.
• Warming Plate: Adjustable (Low/High).
• Power Source: 120V AC, 60Hz, 900W.
• Cord Length: 30 inches.

Controls and Settings

Access functions via front control panel. Buttons: POWER, PROGRAM, HOUR, MINUTE, CLEAN indicator.

Display: LCD shows time, PROGRAM ON indicator, and AUTO OFF timer.

Clock Setting: Hold HOUR and MINUTE to adjust. Programming: Press PROGRAM, then HOUR/MINUTE to set brew time. Auto Shut-Off: Press and hold PROGRAM for 3 seconds to cycle through 0, 2, or 4 hours. Warming Plate: Switch on left side for Low or High. Brew Pause: Simply lift carafe during brewing cycle.

Brewing Coffee

Supports ground coffee; use medium grind for best results.

1. Fill reservoir: Add cold water to desired cup level (5 oz per cup).
2. Add coffee: Place filter in basket, add ground coffee (1 tablespoon per cup).
3. Start brewing: Press POWER button; brewing begins immediately.
4. Pause and serve: Lift carafe during brew to pour a cup, then replace to continue.
5. Programmed brew: Set PROGRAM time; unit will start automatically at set time.
6. Auto shut-off: Coffee maker turns off after selected time (0, 2, or 4 hours).

WARNING! Do not remove filter basket during brewing. Use caution with hot surfaces.

Cleaning & Maintenance

Unplug and cool before cleaning. Wash carafe and filter basket after each use.

1. Daily: Empty grounds, rinse basket and carafe with warm water.
2. Monthly: Descale to remove mineral buildup. Press CLEAN button when light is on and follow instructions (use vinegar solution).
3. Charcoal Filter: Replace every 60 brew cycles or every 2 months.
4. Exterior: Wipe with damp cloth; do not immerse in water.

CAUTION! Do not use abrasive cleaners. Never wash housing in dishwasher.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. Copyright © Cuisinart; trademarks of Conair Corporation. For support, visit www.cuisinart.com or contact 1-800-726-0190.

Troubleshooting

Reset: Unplug for 10 minutes, then plug back in to reset electronics.

Service: 1-800-726-0190; www.cuisinart.com