Cuisinart DGB-600BCA Manual

The Cuisinart DGB-600BCA is a fully automatic 12-cup programmable coffeemaker with an integrated burr grinder, featuring a 24-hour programmability, 1-4 cup setting, auto shut-off, charcoal water filter, gold-tone commercial-style filter, and a stainless steel finish. It grinds beans fresh for each pot and includes settings for coffee strength and grind coarseness. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Brewing Coffee 7. Grinder Operation 8. Cleaning & Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Bean hopper with lid, burr grinder, water reservoir, gold-tone filter basket, glass carafe, warming plate, and control panel.

Feature	Description
Burr Grinder	Integrated grinder with adjustable coarseness settings
Programmable Timer	24-hour advance brew start programming
1-4 Cup Setting	Optimizes brewing for smaller quantities
Auto Shut-Off	Automatically turns off 0-4 hours after brewing
Charcoal Water Filter	Removes impurities for better tasting coffee
Strength Control	Select regular or bold brew strength
Grind Control Dial	Adjustable from fine to coarse grind
LCD Display	Shows time, program status, and settings
Pause & Serve	Allows serving before brewing completes
Audible Signal	Beeps when brewing is complete

Installation

Unpack and inspect contents. Place on clean, dry, level surface.

Remove all packaging materials and stickers.
Wash carafe, filter basket, and charcoal filter holder with warm, soapy water. Rinse and dry.
Insert charcoal water filter into filter holder and soak in water for 15 minutes.
Place filter holder into the water reservoir.
Fill water reservoir completely and run a brewing cycle without coffee to clean the system.

WARNING! Do not immerse base, cord, or plug in water. Ensure unit is unplugged during cleaning.

First-Time Setup

Plug in the coffeemaker; the LCD will illuminate.

Set the clock: Press and hold HOUR and MINUTE buttons to set current time.
Program brew time: Press PROGRAM, then set desired brew time using HOUR and MINUTE.
Set auto shut-off: Press AUTO OFF to select duration (0-4 hours).
Adjust grind: Turn GRIND CONTROL dial to desired setting (1-18).
Select strength: Press STRENGTH for regular or bold.

CAUTION! Ensure the carafe is properly positioned before brewing to avoid spills.

Specifications

Capacity: 12 cups (60 oz).
Grinder Type: Conical burr grinder.
Grind Settings: 18 settings from fine to coarse.
Programmability: 24-hour advance brew start.
Auto Shut-Off: 0 to 4 hours adjustable.
Filter: Gold-tone commercial-style permanent filter.
Water Filter: Charcoal filter included.
Power Source: 120V AC, 60Hz, 1000W.
Dimensions: Approximately 11.5" W x 15.5" H x 8.5" D.
Weight: 10.5 lbs.

Controls and Settings

Control Panel: POWER, PROGRAM, CLOCK, AUTO OFF, STRENGTH, 1-4 CUP, GRIND OFF/BREW ONLY.

Buttons: POWER turns unit on/off; PROGRAM sets brew time; CLOCK sets time; AUTO OFF sets shut-off delay; STRENGTH selects brew strength; 1-4 CUP optimizes small batches; GRIND OFF allows using pre-ground coffee.

Grind Control: Dial with settings 1 (finest) to 18 (coarsest). LCD Display: Shows time, program status, auto off setting, and brew progress.

Brewing Coffee

For fresh-ground coffee or pre-ground coffee.

Fill water reservoir to desired cup level.
Add whole beans to hopper (for grinding) or place pre-ground coffee in filter basket (if using GRIND OFF).
Place empty carafe on warming plate.
Select settings: Strength, 1-4 cup if applicable, grind setting.
Press POWER to start brewing immediately, or ensure PROGRAM is set for delayed brew.
When brewing completes, audible signal sounds. Coffee stays warm on plate per auto-off setting.

Tip: Use the 1-4 cup setting when brewing less than 5 cups for optimal flavor.

Grinder Operation

The burr grinder provides consistent grind size.

Adjust Grind Control dial: Lower numbers for finer grind (espresso), higher for coarser (French press).
For regular drip coffee, start at setting 8-10.
Grind amount is automatically measured based on water amount.
To use pre-ground coffee, press GRIND OFF before brewing and add grounds to filter basket.

WARNING! Never insert utensils or fingers into bean hopper or grinder. Unplug before cleaning.

Cleaning & Maintenance

Regular cleaning ensures optimal performance and longevity.

Daily: Wash carafe, filter basket, and lid with warm soapy water.
Monthly: Descale with vinegar solution (run brew cycle with half vinegar, half water, then run 2 cycles with clean water).
Charcoal Filter: Replace every 60 days or after 60 uses.
Grinder Cleaning: Unplug, remove bean hopper, and wipe burrs with dry brush.
Exterior: Wipe with damp cloth; do not use abrasive cleaners.

CAUTION! Always unplug before cleaning. Never immerse base in water.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. Copyright © Cuisinart; trademarks of Conair Corporation. For support, visit www.cuisinart.com or contact 1-800-726-0190. This appliance is for household use only.

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power/LCD dark	Not plugged in / outlet issue	Ensure plug is secure; try different outlet; check circuit breaker.
Coffee not brewing	Program not set / water empty	Check water level; press POWER for immediate brew; ensure PROGRAM time is correct.
Weak coffee	Grind too coarse / strength setting	Adjust grind to finer setting; select BOLD strength; clean filter basket.
Grinder not working	Hopper empty / GRIND OFF on	Add beans; ensure GRIND OFF is not selected.
Leaking water	Misaligned carafe / overfilled	Ensure carafe is centered under basket; do not exceed 12-cup line.
Burnt taste	Old beans / dirty equipment	Use fresh beans; clean carafe, filter, and descale unit.

Reset: Unplug for 10 seconds, then plug back in to reset electronics.

Service: 1-800-726-0190; www.cuisinart.com