Cuisinart DGB-650BC Grind-and-Brew Thermal Automatic Coffeemaker Manual

The Cuisinart DGB-650BC is a fully automatic 12-cup thermal coffeemaker featuring a built-in burr grinder, programmable settings, a double-wall stainless steel thermal carafe to keep coffee hot for hours, charcoal water filter, and a 24-hour advance brew start. It grinds beans immediately before brewing for maximum freshness. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Grinder hopper with bean selector, Thermal carafe, Charcoal water filter, Control panel with LCD display, Programmable clock/timer, Brew pause feature, Auto shutoff.

Installation

Unpack and inspect all contents. Place on a clean, dry, level, and stable surface away from edges.

1. Remove all packaging materials and tape from inside the grinder hopper and carafe.
2. Wash the thermal carafe, lid, and permanent filter basket with warm, soapy water. Rinse and dry thoroughly.
3. Insert the charcoal water filter into the filter holder in the water reservoir (soak filter first for 15 minutes).
4. Fill the water reservoir with cold water to the 12-cup mark and run a brewing cycle without coffee to clean the system.
5. Plug the power cord into a standard 120V AC electrical outlet.

WARNING! Ensure the coffeemaker is unplugged during cleaning and initial setup. Do not immerse the base, cord, or plug in water.

First-Time Setup

After installation, program the clock and your preferred settings.

1. Set the Clock: Press and hold the HOUR and MINUTE buttons until the correct time is displayed.
2. Set Auto Shutoff: Press the AUTO OFF button to select 0, 2, or 4 hours.
3. Set Brew Strength: Press the BREW STRENGTH button for REGULAR or BOLD.
4. Load Beans: Fill the grinder hopper with whole coffee beans (max ½ lb). Set the BEAN SELECTOR to WHOLE BEAN.
5. Set Grind Coarseness: Turn the GRIND SELECTOR dial to your preferred setting (1-18).
6. Program Brew Start Time (optional): Use the PROGRAM button to set a time for automatic brewing.

CAUTION! Never operate without water in the reservoir. Always ensure the carafe is properly positioned before brewing.

Specifications

• Capacity: 12 cups (5 fl oz per cup).
• Carafe: Double-wall stainless steel thermal, 60 oz.
• Grinder Type: Conical burr grinder with 18 settings.
• Programmability: 24-hour advance brew start; programmable auto shutoff (0, 2, 4 hrs).
• Brew Strength: Selectable (Regular or Bold).
• Filter: Permanent gold-tone filter; includes charcoal water filter.
• Power Source: 120V AC, 60Hz, 1000W.
• Dimensions (approx): 11.5" W x 15.5" H x 8.5" D.
• Weight: 10.5 lbs.

Controls and Settings

Control Panel: POWER button, PROGRAM, CLOCK (HOUR/MINUTE), BREW STRENGTH, AUTO OFF, GRIND OFF, BEAN SELECTOR (WHOLE BEAN/PRE-GROUND).

LCD Display: Shows time, PROGRAM indicator, BREW STRENGTH, AUTO OFF setting, and alerts.

Settings Overview: Clock – Set current time. Program – Set automatic brew start time. Brew Strength – Regular (standard) or Bold (stronger). Auto Off – 0, 2, or 4 hours after brewing. Grind Off – Bypasses grinder for pre-ground coffee. Bean Selector – Switch between whole bean and pre-ground modes.

Programming and Operation

For daily brewing, manual or programmed.

1. Manual Brew: Ensure water reservoir is filled. Place carafe on warming base. Select BEAN setting. Press POWER to start grinding and brewing.
2. Programmed Brew: Set the clock. Press PROGRAM, then HOUR/MINUTE to set desired brew time. Ensure hopper has beans, reservoir has water, and carafe is in place. The unit will start automatically at the set time.
3. Brew Pause: During brewing, you can remove the carafe to pour a cup (up to 20 seconds). Replace carafe to continue brewing.
4. Using Pre-Ground Coffee: Set BEAN SELECTOR to PRE-GROUND. Add coffee to the filter basket. Press POWER to brew (grinder will not operate).

Tip: For best flavor, use fresh, cold water and clean the unit regularly. Adjust grind setting based on coffee type.

Cleaning and Maintenance

Regular cleaning ensures optimal performance and longevity.

1. Daily: Empty and rinse the carafe and filter basket. Wipe the warming base with a damp cloth.
2. Weekly: Clean the grinder by running ¼ cup of uncooked rice through it to remove oils. Discard rice.
3. Monthly: Descale the coffeemaker using a descaling solution or white vinegar mixture (run a cycle with solution, then run 2 cycles with clean water).
4. Charcoal Filter: Replace every 60 uses or every 2 months (whichever comes first).
5. Exterior: Wipe with a soft, damp cloth. Do not use abrasive cleaners.

WARNING! Always unplug before cleaning. Never immerse the base, cord, or plug in water. Do not clean carafe or components in dishwasher unless specified.

Care & Storage

Unplug and allow to cool before storing. Ensure all parts are clean and dry.

CAUTION! Store in a dry place. Do not wrap the cord tightly around the base. Avoid exposure to extreme temperatures.

Regulatory Information

UL Listed. FCC Part 15: Class B digital device; complies with interference limits for residential use. Copyright © Cuisinart. For support, visit www.cuisinart.com or contact 1-800-726-0190.

Troubleshooting

Reset: Unplug for 10 seconds, then plug back in to reset the control panel.

Service: 1-800-726-0190; www.cuisinart.com